Ecodry 3DK is a centralized closed-circuit adiabatic cooling system designed to replace the old cooling tower technology. Installed outside the system, it removes the heat extracted from the process, achieving:

• Better cooling performance with increased heat transfer efficiency
• Outstanding operating costs savings, resulting in a low Total Cost of Ownership
• New standards in terms of Environmental Impact, from both water footprint and total emissions

ADVANTAGES OF ADIABATIC COOLER

A fluid cooler with better performance

• Guaranteed operation with minimum water consumption and maintenance even in extreme climatic conditions, up to 50 °C (122 ˚F) ambient air temperature.

• Safe winter operation without glycol down to an ambient temperature of -40 °C (-40 ˚F).

• High energy savings of fans in partial load operation.

• Compact installation with minimal floor space required between modules.

• High reliability with electrical redundancy and built with 100% non-ferrous materials.

FEATURES OF ECODRY 3DK

Total control

• Maximum water temperature to process: 30/35 °C (86/95 ˚F).

• Cooling capacity: 50 – 10,000 kW (14 – 2,845 tons).

• Water flow to process: 10 – 2,000 m³/hr (45 – 8,805 gpm).

• High efficiency adiabatic chamber for air pre-cooling, for operation in ambient temperatures up to 50 °C (122 ˚F).

• Drainable configuration to prevent freezing.

• Heat exchangers with a wide exchange surface, with copper tubes and aluminum fins with hydrophilic protection.

• Axial fans with DC motors, brushless, inverter driven and individually connected.

• Modular design with pre-assembled stainless steel connection manifolds.

• Stainless steel structure and aluminum access panels.

Cap Cooler is a unit specifically designed for uniform post-cooling of the caps and to guarantee dimensional stability after molding and before handling. The innovative cooling system results in constant quality, drastically reducing ovalization and deformation of the caps. 2 models are available up to a capacity of 70,000 caps/hour or higher.

ADVANTAGES

Reduced consumption

• Easy to install.

• Low energy consumption.

• Suitable for different cap sizes and outputs.

• Small footprint (0.95 m2 / 10 ft2).

MultiStage is an integrated cascade refrigeration system, with water or air condensation, designed to provide high efficiency cooling conditions to processes with a high temperature drop. It consists of refrigeration modules (Modular Chiller) arranged in series and fully exploits this large temperature differential, allowing the stages to operate with the highest evaporation temperatures and, therefore, with the maximum refrigeration performance (COP/EER). MultiStage can be synchronized digitally with the processing line and automatically managed by it.

ADVANTAGES

Unbeatable energy efficiency

• Cascade cooling synchronized with the process.

• High energy efficiency: the highest EER in all working conditions.

• High reliability: units built and tested in the factory.

• Super compact and reliable, factory tested, plug & play concept.

• Easy to install, use, maintain or repair.

• Heat recovery if managed as a heat pump. Hot water up to 60 °C (140 ˚F).

• Each chiller can be easily repaired or replaced in the event of a failure.

FEATURES

Plug & Play system

• Independent refrigeration modules connected in cascade.

• Option with water or air condensation.

• Cooling interval: from -5 to 30 °C (23 to 86 ˚F).

• Cooling capacity: 300 – 2,500 kW (85 to 711 tons) cooling/heating.

• High efficiency inverter driven screw compressors.

• Inverter driven process pumps: from 20 to 150 m3/hr (88 to 660 gpm).

• Web/Scada monitoring interfaces, etc.

• 20 ” Touch screen interface.